Moving Project BumbleBee Rear axle assembly is installed.
Moving Project BumbleBee Another angle of the rear axle assembly installed.
Moving Project BumbleBee Rear wheel on and springs supporting the car's weight.
Moving Project BumbleBee Installed the gas tank (it's empty).
Moving Project BumbleBee Sits much lower with the half the cars weight on the leaf springs.
Moving Project BumbleBee I should have taken a picture before installing the front sub-frame, but here you go.
Moving Project BumbleBee Front fenders are on and starting to looking like a car again.
Moving Project BumbleBee Still a bit bare but just looking to get it rolling for the move.
Moving Project BumbleBee Fender gaps are about the same as when I took it apart but needs adjusting.
Moving Project BumbleBee Doug and my Son (Michael) helped me mount the hood.
Moving Project BumbleBee Now I need to clean under the car before hitting the ground.
Moving Project BumbleBee I also need to clean the trunk to make space for the removed parts and new parts.
Moving Project BumbleBee I almost forgot that I had the trim and other things in the passenger area.
Moving Project BumbleBee All cleaned out and packing. I can hardly believe the drive shaft fits in the trunk.
Moving Project BumbleBee Still packing up for the move.
Moving Project BumbleBee Trunk is loaded. The lid almost doesn't close. Notice the bumblebee keychain.
Moving Project BumbleBee Packing parts in the passenger area. Hard to believe all these parts fit on the car
Moving Project BumbleBee More parts in the back seat and package tray area.
Moving Project BumbleBee Still on blocks but nearly ready to roll.
Moving Project BumbleBee Here's a shot of the full trunk space.
Moving Project BumbleBee I just need to load the dash pad and other trim pieces but nearly full here too.
Moving Project BumbleBee Still on jack stands and blocks. I still need to clean under the car.
Moving Project BumbleBee Yes been the engine and....(next image)
Moving Project BumbleBee Transmission are installed.
Moving Project BumbleBee I lowered the hood for a few pictures and installed the bumper.
Moving Project BumbleBee Driver's side hood to fender gap. Not too bad for an electronics guy.
Moving Project BumbleBee Passenger's side hood to fender gap.
Moving Project BumbleBee Now it's ready to roll into a trailer. I have two friends coming to help me load and unload at a storage container.
